In your magic "crab" you need to connect pin CS to GND.pepeEL wrote: [*]Pull EEPROM CS (you have to locate it) to LOW to select the EEPROM on SPI.
Can you explaine me more ?
No idea, never used it.pepeEL wrote: [*]Set up some Arduino or professional programmer (it MUST be 3V!!!!) to read//write into M25PE20 EEPROMS
Can i use CH341A programmer on USB ?
I've sent you that file via our support desk. It has these zero bytes skipped. The .bin on the server have these zero paddings.pepeEL wrote: [*]Write at 0x7800 the .bin file above (full file byte per byte skipping 0x1800 = 6144 bytes)
Can i write all file without this ? My programmer write all. Idont see option to skip bytes
Right. The address is in hex because we use it in hex. convert to decimal.pepeEL wrote: [*]Then write 1 at 0x77ff
What do you mean write 1 at 0x77ff ? write numer"1" to adress 0x77ff ?
Disconnect CS pin from GND. See 1pepeEL wrote: [*]Release CS
What do you mean ?
Connect RST on 6pin connector of RaZberry to GND and the disconnect.pepeEL wrote: [*]Pull RST to LOW and the release (to reboot Z-Wave chip)
What do you mean ?
Well, if this is not enough, just ship it us.pepeEL wrote: Can you explaine me more... ?