Adding Door Sensor Open Z-Wave Device failed

Discussions about RaZberry - Z-Wave board for Raspberry computer
Post Reply
meir.ivry
Posts: 3
Joined: 07 Sep 2018 17:52

Adding Door Sensor Open Z-Wave Device failed

Post by meir.ivry » 10 Sep 2018 09:48

Hello,

I'm newbe.
I bought Razberry 2 and followed the instructions for installation on Openhabian.
I have the z-way-server up and running and I can login to the web interface (http://openhabianpi:8083).

I have a Door Open Sensor by Septu, Model IM20.
My friend and I tested it on his SmartThings and it works fine.

I tried to add it through the web interface (http://openhabianpi:8083) using the following steps:
  • Selected Devices from the Menu
  • On the Z-wave line clicked "add new"
  • Clicked "add new Z-wave device …"
  • Put the Door Sensor near by the Razberry
  • Clicked on its inclusion
  • Clicked "Start" button
After a while I got this message:
==============================
SmartHome UI - Warning
INCLUSION take a long time to start up
==================================

Please help.

meir.ivry
Posts: 3
Joined: 07 Sep 2018 17:52

Re: Adding Door Sensor Open Z-Wave Device failed

Post by meir.ivry » 10 Sep 2018 23:05

Ok, figured it out myself.
Before clicking "Start" inclusion, I had to choose "unsecure" inclusion since this device probably does not support secure mode.

Post Reply