Wrong information in update window

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
donquixote0906
Posts: 6
Joined: 12 Dec 2017 17:21

Wrong information in update window

Post by donquixote0906 » 09 Sep 2019 22:05

Hi,
under management -> firmware update the correct firmware 3.0.0 is displayed.
When i open the firmware update window the firmware is 2.8.0 and it is possible to
update version 3.0.0.
Is it a bug?
Thanks

platypus
Posts: 15
Joined: 28 Apr 2019 16:32

Re: Wrong information in update window

Post by platypus » 12 Sep 2019 21:26

To me it looks like a bug. I can't see any version in the firmware update window. It shows:
prm_fw_curver: Err(1.18.3): main.c: 501: The spawned process 'get_z-way_version.sh' has exited with code 1 and says:
��

otverber
Posts: 9
Joined: 28 Mar 2018 20:17

Re: Wrong information in update window

Post by otverber » 14 Sep 2019 00:09

Same here:
Firmware Update
prm_fw_curver: Err(1.18.3): main.c: 501: The spawned process 'get_z-way_version.sh' has exited with code 1 and says:
��
The current firmware version is

however its now possible to upgrade to: update to latest (v3.0.1 )

after 2 clean reinstallations of v3.0.0 in half a week i will not try this update until confirmed that its safe..

Post Reply