"missing" Battery Devices after reinstallation

Discussions about Z-Way software and Z-Wave technology in general
Post Reply
Jarry
Posts: 3
Joined: 08 Apr 2018 20:24

"missing" Battery Devices after reinstallation

Post by Jarry » 12 Oct 2019 13:55

Hi together,

last night my SD Card in my Raspi 2 died.
After reinstallation (and upgrade to a Pi3 and v3.0.0) the system can not communicate with my battery powered devices (Fibaro smoke sensor, Aeotec wallmote and nodon Wallswitch).
I had the chance to use an older backup, and all devices were found in general, but all with generic names like "BatteryDevice _10"
Even the mains-operated devices had the same problem, but with a "force Interview" everything went fine. Even a battery operated Danfoss Radiator Valve Thermostat went fine.
But no chance with the other battery devices. Maybe a complete exclusion/inclusion cycle will help, but this is only the last option, because of all scenes, and groups needs to be adjusted afterwards.
Any ideas?

best regards

Jarry

User avatar
PoltoS
Posts: 4978
Joined: 26 Jan 2011 19:36

Re: "missing" Battery Devices after reinstallation

Post by PoltoS » 13 Oct 2019 16:22

This means you lost all data if smart home. Please restore the backup from smarthome

Jarry
Posts: 3
Joined: 08 Apr 2018 20:24

Re: "missing" Battery Devices after reinstallation

Post by Jarry » 13 Oct 2019 20:58

i already restored it from the backup,
but this was the outcome. all details about all devices were lost. for the mains powered devices, i had the chances to "relearn" all details, but most of the battery powered devices, will not "talk" to the base, even when they are awake

Post Reply