forum

Thanks for the reply and info. Good point about battery running out, it's surprising that the speaker drains it so quickly. I turned off the audio alarms for now. Per your suggestions, and looking at the manual for this device (http://www.fibaro.com/manuals/en/FGFS-101-Flood-Sensor/FGFS-101-Flood-Se...

btw I tried upgrading now, and under " preferences->modules->peripherals" I found "Z-Wave binding module" but not "Z-Wave Gate device creator" or "Z-Wave device dead detection"?

So last month I got a Fibaro flood sensor. The interview succeeds and I get an AlarmSensor command among others. However I can't seem to figure out which value changes when I soak it in water. At that point, the sensor detects it and does a visual & audio alarm. But, sensorState under AlarmSenso...

I ran into this same issue as well and then downgraded. We all definitely appreciate your help. Note that for most of us reading this, we don't read all the threads so we miss stuff like this. It would be great if these instructions, if they're necessary for successful usage, were printed with the e...

I see, thanks. I got confused by the Changelog text which didn't indicate that it was alpha.

I'm trying to see if the new version solves some problems that I've been having.

http://razberry.z-wave.me/index.php?id=24 seems to indicate that 2.0.0 is released. However if I run "wget -q -O - razberry.z-wave.me/install | sudo bash" per the instructions I'm still on v1.7.2?

Thanks

Thanks for the reply Poltorak. I'm not sure if you're referring to the GE remote or the original remote that I had for my curtain?

Where should the association groups show up in Razberry, under the curtain or the remote?

In desperation, I bought the GE 45600 Z-Wave remote control. I paired it with the Razberry and it shows up as a device.

However I don't see association groups anywhere in the expert UI? Is this supposed to show up under the curtain motor or under the remote, or elsewhere? Thanks

by the way, I was looking around the z-wave website gallery and I found that my remote is just a rebranded version of http://products.z-wavealliance.org/products/259. The Z-Wave Certification # printed on the back of my remote is the same as the one linked to from above (http://products.z-waveallian...

I don't see anywhere to edit the association of either the curtain or remote? I've attached screenshots to show you what I'm seeing.