forum

Today I created a new image and followed the instructions at http://www.openremote.org/display/docs/OpenRemote+2.0+How+To+-+Z-Wave+with+Razberry Again, I got to the point of setting the binding to dev/ttyAMA0. Again, the "Open the Old Expert UI . Switch to Expert mode in the lower right corner....

log file is attached.

Thank you again for your help!

Please tell me the log file name

I see the Z-Wave binding in the Preferences -> Automation and it is set to /dev/ttyAMA0. Now I see the Warning: Can not start Z-Wave binding: Error: Bad data - communication failed

Thank you for the response. At port 8083, under the Z-Way Home Automation UI, I see warning message "Can not start Z-ave binding: Error: Binding with name 'zway' already exists. If I go to modules, I see that SwitchControlGenerator and OpenRemoteHelpers are used. When I try to "add" Z...

Is there a step by step document that goes further than just installing the Razberry image onto the SD card the plugging the card on to the Pi? So far, I was able to access the system at port 8084 and update firmware to 2.0.0, but how do I really test the communication to the daughter card to verify...