forum

The distant Fibarro motion sensor has now settled down and the last 6 wake-up communications have all been 60 msec except one at 150. So all much much better. I also upgraded ZWay to v4.1.4 (from something like v4.1.0 but I didn't check). I tried upgrading a year ago and found that both my Fibarro m...

Just confirmingg the results of updating to Serial API Version 07.42 etc as above. The improvement after a Re-organisation and 4 days use has been remarkable. Before the re-organisation I had some communication failures similar to before, which normally resulted in a steady degadation and Razberry f...

Hi, Serial API Version was: 07.13 I've now managed to update, via several stages and, initially, two Update Failed messages, to your version: Firmware Library Type: Static Controller SDK Version: 7.21.00 Serial API Version: 07.42 So many thanks for the info. I am now hoping for a major imprevement. ...

Further info: The Soft Reset after the Hard one does not work. Hard Reset followed by a reboot of the Pi does.

A bit of further information. Following running that command, I re-booted the Pi (I did not power it off, just a soft re-boot), and it all seems to work again. This has never happened before, so I assume the hard reset worked, and re-booting the Pi reset the software. I will try the Soft Reset next ...

Has anyone tried the Hard Reset below? echo -ne "\x01\x03\x00\x08\xf4" > /dev/ttyAMA0 I have tried it after my Razberry 5 seized up as from 07:00 am, but it still won't switch anything. Normally I would have to power off the Pi (3) and turn it back on again, as mentioned in other posts, bu...

I use a Fibaro FGMS-001 PIR multi-sensor to turn on the heating in an area of my house when someone is detected in there. I have written my own Python system so no third party app is involved (such as Home Assistant). This has been working for several years, using Zway on a Raspberry Pi 3. I now use...

I'm not sure of exactly when it happened. It's run every 3 hours. I've looked at the z-way-server.log for each episode from 1800 the previous day to 1500 of the day (20 July), pulled out the relevant secion, and used Notepad++ to run a Compare. There are differences in the data values, but no obviou...

Using Expert UI, under Network / Timing Info, I sometimes see a series of red 1's as the times (under Last Packets in 10 ms units). Red indicates a failed transmission, but if so, surely it would not take 10 msec?? So what does this mean? When I get a genuine failure, it is more like a red 250 (2.5 ...

I am trying to upgrade from a series 500 Razberry to a Razberry7 . First, on power up I get only a very short flash from the on-board LED(s). Poltos says above this is normal. I get the Expert UI web page and the controller info which says "Z-Wave Chip: ZW0700", so I assume I am connected....