forum

I am just curious to know: What steps are necessary to "migrate" my current configuration (devices, rules, ...) to a new raspberry and a new razberry controller? I am thinking of getting the latest controller and my raspberry is somewhat "old"... Anyone did this in the past? Than...

Hej everybody, some of my devices suddenly failed (is actually dead) and I wanted to replace that device. When I go to the expert frontend > Network > Control and select my device to replace it, a green message appears in the device management section where I can include / exclude devices. The messa...

Hej all,

since I updated to the latest version (v2.2.3) I cannot select any device descriptions anymore because they are gone completely from the expert ui. Please see the image attached.
Any suggestions?

Thanks in advance and kind regards
Dennis

Thanks for the quick reply

hej everybody, everytime when I startup the z-way-server I get the following error message "[zway] Error returned from zway_fc_zme_freq_change(zway, 0xFF, NULL, NULL, NULL): Function class not supported by the hardware (-4)" followed by multiple lines of the following error message (around...

I've experienced this as well, but not as frequent as you have. It is more about 1x a month. I've noticed that the zway server stopped working after the router was shutdown / wireless connectivity has dropped. I've experienced this at least two times. Can you confirm that you can traceback your issu...

If I understand correctly none of your five Devices is mains powered and therefore will go to sleep and only wake up in well-defined intervals (lets say every 15 minutes). They will not receive any commands while they söeep and will not forwatd messages from or to other devices. You can use a wall p...

Nobody has any experience? Is there a time estimate when 2.2.3 is going to be released? Is it possible to put images manually to the server without uploading them via the web ui? Is there any other way to set the device description? For now I cannot set any properties on some wallplugs and motion se...

Did you install the Base Module App as well? It is a prerequisite for the Presence App. Let me know if this helps

Kind regards
Dennis

How can I perform a re-include? I've tried (maybe the wrong way) by setting the controller into inclusion mode and pressed the button on the device three times as stated in the device description (accessable via Expert UI). Unfortunately it did not work.