Search found 6 matches

by homespear
24 Jul 2016 11:30
Forum: Discussions in English
Topic: Fibaro Motion Sensor don't change status
Replies: 12
Views: 6080

Re: Fibaro Motion Sensor don't change status

OK. I added an association with the z-way controller with the motion group and that gave me a remote device that is correctly set to on or off according to the motion sensor. I feel this is a better solution than a virtual HTTP device that has to poll the Z-way device every second.
by homespear
24 Jul 2016 11:12
Forum: RaZberry
Topic: How to do automation? I'm confused.
Replies: 1
Views: 1377

How to do automation? I'm confused.

So I just recently got into Z-wave and have a Razberry up and running with be latest firmware. However I'm a bit confused about how to actually automate my devices. The manual references a HA-interface where you can create scenes but this interface is apparently gone now according to the release not...
by homespear
24 Jul 2016 11:06
Forum: RaZberry
Topic: Problem with Fibaro Motion Sensor
Replies: 82
Views: 61399

Re: Problem with Fibaro Motion Sensor

Any news? I can't get the motion detection to work with my sensor either (3.2).

Have you messed around with associations for the device at all? Read somewhere here that someone claimed
to have made it work properly by configuring associations for the motion group.
by homespear
24 Jul 2016 11:00
Forum: Discussions in English
Topic: Fibaro Motion Sensor don't change status
Replies: 12
Views: 6080

Re: Fibaro Motion Sensor don't change status

Thanks for this. I'm also having issues with the Fibaro Motion Sensor (3.20) and will try out your approach.

By the way, have you messed around with the associations at all or are they all at their default settings. Could you post a screenshot of it?
by homespear
06 Jul 2016 15:43
Forum: Device specific
Topic: Fibaro FGMS-001 v3.2
Replies: 1
Views: 1943

Fibaro FGMS-001 v3.2

So I got a Fibaro Multi Sensor and added it to Z-Way (Razbian). Temperature and Luminescence values show up fine, but I can't figure out how to get the motion sensor working. The regular UI just shows a "Fibar Group General Purpose alarm Alarm" device which is apparently set to "On". The Expert UI i...
by homespear
06 Jul 2016 00:13
Forum: RaZberry
Topic: Room-based temperature adjustment
Replies: 1
Views: 1250

Room-based temperature adjustment

So I have a couple of Danfoss Living Connect radiator thermostats installed and connected through Z-Wave. The instructions from Danfoss state that if I manually adjust the temperature on the thermostat then the Z-wave controller should adjust all the other thermostats in the same room as well. This ...