Search found 6 matches
- 24 Jul 2016 11:30
- Forum: Discussions in English
- Topic: Fibaro Motion Sensor don't change status
- Replies: 12
- Views: 13192
Re: Fibaro Motion Sensor don't change status
OK. I added an association with the z-way controller with the motion group and that gave me a remote device that is correctly set to on or off according to the motion sensor. I feel this is a better solution than a virtual HTTP device that has to poll the Z-way device every second.
- 24 Jul 2016 11:12
- Forum: RaZberry
- Topic: How to do automation? I'm confused.
- Replies: 1
- Views: 2816
How to do automation? I'm confused.
So I just recently got into Z-wave and have a Razberry up and running with be latest firmware. However I'm a bit confused about how to actually automate my devices. The manual references a HA-interface where you can create scenes but this interface is apparently gone now according to the release not...
- 24 Jul 2016 11:06
- Forum: RaZberry
- Topic: Problem with Fibaro Motion Sensor
- Replies: 82
- Views: 107725
Re: Problem with Fibaro Motion Sensor
Any news? I can't get the motion detection to work with my sensor either (3.2).
Have you messed around with associations for the device at all? Read somewhere here that someone claimed
to have made it work properly by configuring associations for the motion group.
Have you messed around with associations for the device at all? Read somewhere here that someone claimed
to have made it work properly by configuring associations for the motion group.
- 24 Jul 2016 11:00
- Forum: Discussions in English
- Topic: Fibaro Motion Sensor don't change status
- Replies: 12
- Views: 13192
Re: Fibaro Motion Sensor don't change status
Thanks for this. I'm also having issues with the Fibaro Motion Sensor (3.20) and will try out your approach.
By the way, have you messed around with the associations at all or are they all at their default settings. Could you post a screenshot of it?
By the way, have you messed around with the associations at all or are they all at their default settings. Could you post a screenshot of it?
- 06 Jul 2016 15:43
- Forum: Device specific
- Topic: Fibaro FGMS-001 v3.2
- Replies: 1
- Views: 3657
Fibaro FGMS-001 v3.2
So I got a Fibaro Multi Sensor and added it to Z-Way (Razbian). Temperature and Luminescence values show up fine, but I can't figure out how to get the motion sensor working. The regular UI just shows a "Fibar Group General Purpose alarm Alarm" device which is apparently set to "On&qu...
- 06 Jul 2016 00:13
- Forum: RaZberry
- Topic: Room-based temperature adjustment
- Replies: 1
- Views: 2692
Room-based temperature adjustment
So I have a couple of Danfoss Living Connect radiator thermostats installed and connected through Z-Wave. The instructions from Danfoss state that if I manually adjust the temperature on the thermostat then the Z-wave controller should adjust all the other thermostats in the same room as well. This ...