forum

Yes, you can connect power to 5V or 3V3 pins directly For 5->3.3 DC-DC we use MCP1700. It can source up to 250 mA total I want to supply Z-Uno with 12V, supplied to pins 1 and 3 (7-18V input / gnd). The plan is to use Z-Uno's DCDC converter to supply peripheral components (like MAX3232) from 3V3 ou...

Hi All, It is working now! :mrgreen: I tried to switch to Rescue mode as proposed by some (hold down the Service Button and then hold down the Reset button, wait for a second, release the Reset button then release the Service Button.) After this I tried the Exclude by pressing 3 times the Service bu...

Hi Michael. Reset itself is working ok..but i still am not able to exclude. The default sketch (motion detector) is still working ok. In the Fibaro environment I see the device labeled as "not configured", as I tried to reconfigure Z-Uno from there as well. It might be that this is the rea...

Hi, Did you have any luck excluding (and re-including) your Zuno?? I might have the same issue. My Z-uno doesn't seem to react to any Exclude / Include commands from my Fibaro HC2.

I did try the reset, am close to the controller when I try to exclude etc.

Any ideas are most welcome.

Thanks,