forum

PoltoS wrote:Yes, you can connect power to 5V or 3V3 pins directly

For 5->3.3 DC-DC we use MCP1700. It can source up to 250 mA total

it's a good news to be able to avoid micro USB as power input

My HC version is 4.090....

I thought that with 7 channels, I should have one main device and 7 child devices...so every 708.x child devices was normal but it is not the case...

I will create a ticket to fibaro support for more information

Hi All I modified the 10 channels sketch to create my own with only 7 channels. ZUNO_SETUP_CHANNELS( ZUNO_SWITCH_BINARY(getterSwitch1, setterSwitch1), ZUNO_SWITCH_BINARY(getterSwitch2, setterSwitch2), ZUNO_SWITCH_BINARY(getterSwitch3, setterSwitch3), ZUNO_SENSOR_MULTILEVEL_CO2_LEVEL(getterMonoxyde),...

oups I forgot this information

Ok I added a delay of 31s and it seems working fine... but mayne a bypass would be a good idea for some sensors like CO2, fire, luminance and so on...

Very good news, everything is working fine now.. I installed again arduino IDE to be sure USB drivers were well installed Then I upgrade to 2.05. I was in 0.67 !!! I understood available and proposed versions depend on the url you suggested, right ? The serial output window is fine too, I can see va...

Thanks a lot for all these informations. Hope it will works. You'are right for all my versions
I spent 3 hours yesterday with port issues. Very frustrating
I will follow your recommendations this week end and will inform you about the result...

So I added following code within Certified 10 Channels Sketch. When I open the console from arduino IDE, I don't have anything !!! // Luminosity Serial.println("valeur: "); Serial.println(analogRead(LumiPin)); currentLumiValue = (byte)(100 - analogRead(LumiPin)*25/256); if ((currentLumiVal...

thanks for the reply... yes I just want to check the value from the sensor (to konow if it is compatible first and if I get date from it)... So I add the command but now I have an other issue.. I can't upload the sketch. Everything seems to be ok for the port, I selected it but it is written "D...

Hi

same for me. How can we check data we are processing. I use a Grove light sensor and I would like to check if it works with Certified 10 Channels Sketch

Thanks