forum

Hi. Just installed 5.39 on one of my UZBs. A) So far, no dead devices on restart. Will report if they show up. B) BUG : This no longer works: 5.06: LED can be turned off: Change it via IP:8083/JS/Run/zway.NVMExtWriteLongBuffer(0x6510,[XX]), where XX is: 0x00 LED used only for memory test when device...

Hi. Thank you for posting the 5.39 update, regardless if it helps or not... Question: I am running: UZB/5.36/48059 https://service.z-wave.me/expertui/uzb-stats/versions-graph.html?hw=277&with_hidden To make the journey to 5.39 I need to change my bootloader to 40196. Can this be done directly vi...

Yeah I have had this happening for years now... I restart often as I'm always adding things... But again I'll state, it doesn't really bother me too much as I don't use the z-way-server automation engine / GUI at all... What does is the aimless additional packets every 5 minutes (multiply by 7-8 dev...

So this is kind of a two part bug, the first part I have not traced... And frankly wont bother as my solution below works for me: PART 1: Sometimes on restarting z-way-server, SOME (not all) battery devices will switch into a dead state (isFailed.value=true). Not sure the cause of this, unlikely as ...

I now understand the general syntax... I was getting a little mixed up with the leading / tailing bytes. Must say, wow this is quite a bit faster. I understand the logic behind the Set -> Get behavior, but as my use case is slightly advanced this is the way to go. I have been watching my timing / ro...

Yes that is probably the way I would go, but for now I will leave this socat solution in place. I am running my z-way-servers on fairly powerful machines (one on a i5 8250 and one on a VM on my APU2) so there is quite a bit of head room to spawn a few processes here and there. After the sun went dow...

This works great for me, question though... How does one go about sending to instance 1 / 2?

Thanks!

Before I begin I love these sensors... Saves me from having to drill holes in my doors, which I am sure I would end up fucking up and ruining a $XXXX hard wood door ;) So this is in no ways a knock on Sensative... I will be purchasing their 700 series when they hit market. I found an issue using zsn...

Having recently swapped all my 433.92 inwall's to fibaros I am doing quite a bit of work on updating / cleaning up / speeding up my home auto setup. I'll share some of the things I am doing since I am using z-way-server as the interface to my z-wave mesh. Here's the first one: I used socket.send(......

As the title states...

Will we ever see a firmware for zuno 500 series with 6.71 or higher?

Thanks!