forum

Hi,
The dimmer in Z-Uno receives a "value" between 0-99 from the controller. My question is if I'm with a switch on a digital input on the z-uno can bring "value" to 0, both in the z-uno and the controller
/R

Hi,
I have a working dimming sketch based on the code from the 10 channel example.

My question is whether it is possible to change the code so that a switch / button on a digital input on the Z-Uno resets the dimmer sketch to zero when the button is pressed for about two seconds
/R

Hi,
it is possible to change the dimmer "value" in the dimmer sketch to zero with a switch to a digital input?

Have tried but the controller does not change status to "off"

Thanks in Advance
/R

OK, should I, in my case, connect the capacitor in parallel with the 300K?

/ Rogga

Thanks Michael!
I will measure the voltage of a control circuit that I want to impact as little as possible. My input voltage is <5V. I might choose 200K and 300K. I can not understand the capacitor in a voltage divider?

Thanks for your help

Rogga

Hello, Have you figured out the appropriate values ​​of the voltage divider? I need to convert 5V to about 3.3V for analogRead on A2 and A3. I planning to use two resistors, 330K and 180K. At 5V, I get 3.23 V over 330K to earth, then I have a little margin. I'll get the right value in the controller...

Bad news for me. Planning control a relay from Pin 17 to make it work on the circuit board layout. I did not manage to read analog values ​​from input A2 and A3 to my Fibaro. My code is based on the 10 channel example. I will patiently wait for the next version and hope you manage to bring order to ...

Thank you very much. It works great

/Rogga

Hi Z-wave-enthusiasts, I have an idea that I don't know if it’s possible. I understand that it’s not possible to install the libraries to Adafruits NeoPixels (WS2812) and MCP 4725 (DAC) in Z-Uno at the moment. I need MCP 4725 to be able to control an heat pump through a variable output voltage (0-5V...

Wishing functionality for libraries to Adafruits NeoPixels (WS2812) and MCP 4725 (DAC).

Is there any plan for that?