forum

It seems that the chip was faulty, I received new one from the supplier, and after adding it - things started to work like a charm!

Hi pierre2302, the command line content was in a copy paste above, it does contain the set chars that you were referring to. Additionally, I've taken the .img from razberry site, and installed it into clean SD, still the same problem. When I try to configure the Z-Wave component in the home automati...

I wonder if there's anyone who can help with this part: Wrong pins: RaZberry should be installed as on the image in the manual (like shown on the front page of this site). Configuration of ttyAMA0 went wrong during installation. Check /etc/inittab and /boot/cmdline.txt to have all mentions of ttyAMA...

I've read this from the KNOWN PROBLEMS: I just got my RaZberry, but it does not work If you see in the log on of these lines: Opened device: /dev/ttyAMA0 ..... Notification: critical (z-wave): Can not start Z-Wave binding: Error: Bad data - communication failed First make sure the LED goes on for 1 ...

Here's the latest log entries: [2017-11-02 12:00:22.384] [D] [zway] Opened device: /dev/ttyAMA0 [2017-11-02 12:00:22.385] [D] [zway] Worker thread successfully created [2017-11-02 12:00:22.385] [D] [zway] Worker thread entry point [2017-11-02 12:00:22.385] [zway] Adding job: Get controller info and ...

Hi, Issue, enabling the SmartHome software to work with the RazBerry2 module is not working. Following Error message persists: An unexpected error occurred while initialising the Z-Wave controller data. Please check 1.) if the controller is plugged in correctly, 2.) that in the app 'Z-Wave Network A...