forum

Hi, Thanks for your reply. The switch is not plugged in at all so not sure how it can respond to anything. I restarted Z-Way and did the Call for NIF, which gets repeated: Request NIF from a node - No RESPONSE received before timeout And then stops. But on the Network Control page there's no droplis...

I can still see it trying hours later - shouldn't there be a limit to the loop ?

Hi - re this - "for device specific notifications you can do it", where exactly ? Is the "controller user interface" the :8083/smarthome or the :8083/expert UI ? I can see a gear icon next to the device in the smarthome UI, [ Configuration | Devices | Manage ] but there is no not...

Hi, I have a broken Fibaro double switch (among other devices) that I want to remove. In [ Expert UI / Network Control / Network Maintenance ] no devices are listed next to "Remove Failed Node" As suggested here, I've gone into [ Configuration / Device / Interview ] and clicked "Call ...

Hi,

Thanks - that's good to know.

Just to check, aren't the UART PINS 8 and 10 ?

Regards

Hello, I have the following setup (shown vertically): RaZberry 7 Pro Waveshare UPS HAT Rasberry Pi 3 So the RaZberry is connected to the UPS HAT which sits on top of the Pi. The RaZberry appears to use pins 1-10. I used https://z-wave.me/z-way/download-z-way/ for the OS and Z-Way software, The Pi, U...

Perfect, thank you:

Configuration | Expert Commands | Device Settings
mapBasicSetToSpecificReport=true
acceptSetSecurityLevel=0

I am now receiving the events.

Hello, I switched to a RaZberry 7 Pro and my FGBS-001 Universal Sensor is no longer sending reports when IN1 changes. The logs show the below: [2023-03-17 10:12:59.022] [D] [zway] SETDATA devices.41.data.lastReceived = 0 (0x00000000) [2023-03-17 10:12:59.023] [W] [zway] Ignoring Set packet recieved ...