forum

Anybody that have success using the Mathematica APP?

From two of my Z-WAVE.ME controllers I have enabled the IOS APP on my IPhone. I however get a huge amount of a (one) specific system noticiation related to an APP in teh Z-WAVE.ME controller that sends data to InfluxDB.

Please enclosed ZIP file for more details.

Anybody that can support ?

Dear micky1500

I didi a monit -V and got the message that I had "version 5.20.0".

Did a "sudo apt install -y monit" , but get a message that I have the newest version 5.20.0.

Dear Poltos Thankyou for the reply. The location of the property where the Z-Unos's are located is in a holiday house Greece and I are currently back home in Norway, so I have limlited chanche to to the upgrade. 1. Both Z-Uno's are powvered by a ABB 230/24 Volt transformer. The quality shoudl be goo...

Monit installed according to Isakssons' explanation as per 04 Apr 2017 21:39.

However if I choose to reboot me Rasepberry PI, I need to restart the Monit program with "sudo Monit reload", any way this could be done in teh program when teh Raspeberry Pi boots?

Dear micy1500

Thank you for your advice, I will stop the controller and delete the log file.

I have recently (210721) updated one of my razberry's to version 3.1.4. The program reported that the process was successful. Rigth after the update I get a lot of messages reading "Could Not Post to InfluxDB statistics". See enclosed file for information. However the Razberry do post tran...

I have two z-uno´s working with the same controller. The oldest bougth and in operation since 2019, Z-UNO01, has according to the Z-wave expert UI - in teh Firmware Update a Application Version 2.15. The newest bougth and in operation this year (2021), Z-UNO02, has has according to the Z-wave expert...

Anuone taht can confirm that the Heatit Z-Dim works with the Z-wave-me controller ?

https://www.eldirekte.no/heatit-z-dim-v ... 5MQAvD_BwE

I have installed the following sketch on one of my Z_UNIO´s, see below. sketch_100421.zip I have used PIN 6,5,4,3 -for sensors that are based on 5 VOLT input. These are working fine. In addition I have used the 11, One WIre connection for one ds18b20 Temperature sensor. I htried first three, but tha...