forum

Thanks for your help PoltoS. I could not find my jumper wires to test what you were suggesting and kind of lost interest in debugging it further. I decided to return my RazBerry and go with another solution instead.

Just to make sure i understood this correctly. You are suggesting remove the module and I short TX(pin 8)and RX (pin 10) on my raspberry pi and then check what I see in z-way server logs ?

Thanks for your response. I tried what you suggested. I get "Something went wrong" error when I try to save the configuration on Zwave Network Access. Zway server logs still have [2020-04-29 19:51:23.765] [I] [zway] Adding job: Get controller info and supported function classes [2020-04-29...

Just received my Razberry 2 and connected it to my Raspberry pi 3B+ . I mounted it to the Pi and wrote https://razberry.z-wave.me/z-way-server/razberry.img.zip to an SD card and booted it up. The module LEDs bink when the pi boots. I'm unsure if its supposed to blink afterwards or not but mine did n...