forum

Hi Alex,

You answered my question and then some.

Thank you very much,
Jack

Hi, I am trying to upload a default configuration to my Z-UNO Module based devices using restoreNVM, but I can not find any documentation on where in the EEPROM the values are placed. I assume that they are placed in the 256B area between 0x2000 and 0x20FF, but as the 32 parameters only occupy 64 by...

I am designing a new wall switch using the Z-Uno module and I would like to use a LED for signaling that the device in in “learn” mode, just like the Z-Uno. Is it possible to get one of the GPIO pins on the module to act as the red service led on the Z-Uno?

I have a question to the specifications of the Z-Uno and the Z-Uno module. I have used the Z-Uno for prototyping, and I am now going to convert the prototype into a usable product utilizing the smaller Z-Uno module. I looked at the specs for the GPIO pins and to my surprise the specs are not the sam...

Thank you. Great news

Jack

Hi, Just started designing a new project using Z-Uno and wanted to use Z-Uno Module due to size constraints. Bought a Z-Uno for my initial testing and a Z-Uno module for my prototype and after that I need about 20 more. I had difficulties finding these boards, so before going any further I asked zwa...