forum

PoltoS wrote: ↑

20 May 2022 01:37

The u.fl is not connected by default. You need to turn 90 degrees the R0 jumper (closest to the chip)

I have a Z-Uno 2 ver 6 board. There is no R0 - should it be R7?

For the Z-Uno rev 1 do you need to close S1 to connect the u.fl socket?

Hi, I have the following sketch that used to work on the old Fibaro HC3 z-wave engine, but since migrating to the new engine (3) and the latest firmware (5.130.64) the moment I add a binary switch into the sketch, I no longer see all the sensors and switches declared in the sketch - but only a subse...

Hi, I am a Mac user. After initially installing the VS plugin I managed to compile code successfully and upload it to the Z-Uno Gen 2 and everything worked as expected. However, the next day when I restarted VS the plugin initialised ok, but when I try to run any of the plugin command (verify, set f...

In the link posted above the documents still refer to using the Arduino IDE for coding - what about support for Visual Studio?

For module the version with the u.fl connector is the one I would use.

Any details on the new module? When will you have a form factor available for PCB design?

Any update on when we can expect this?

When can we expect the new version?

Any update on this?