forum

Any update on this?

PoltoS wrote: ↑

11 Jun 2021 01:33

We hope to dispatch them late June, early July.

Any update on dispatching?
Thanks

Thanks, crossing my fingers...

Hello @poltos
I have a zuno in backorder for over a month now (Belgium). Any update on this production delay for Europe? I guess this is the reason why my order keeps getting delayed.
Thanks

Thanks a lot for this very complete feedback Peter! No oscilloscope or logic analyser (yet) in my lab. The sketch was a sleeping one. The USB port is 'connecting' but not usable - windows gives an error - I cannot start any upload. I'll take your recommendation on the resistors. I have indeed connec...

Thanks for getting back. D5 seems to be dead, other diodes test correctly. Note that I unsoldered R12 for low power long ago. Should 5V power (via usb) still work then? It doesn't but I guess if D5 is dead that explains. 5V pin measures 1.25V when powered from USB. I already needed to power via 3V f...

Seems the voltage was indeed a little over 3.3, but not higher than 3.42.
The larger components I checked are rated for 3.6. Could one component have failed first and be replaceable?

Thanks it just happened when I reconnected the battery.
I'm afraid it might have been a voltage spike somehow. Not sure I understand though, worked fine before and can't find anything wrong with the circuit.

Yes rescue is what I've been using a lot since the zuno is asleep - low power mode and R12 removed. The LEDs are not blinking, they are solid (green and red low intensity though). When I release the reset button the green flashes at release. That's all it seems to do. :cry: And it seems the zuno is ...

Worked perfectly fine until I reconnected everything in my project. I now only get white led and red and green halflit. When releasing reset the green flashes. No recovery procedures seem to work (stop the sketch, reset).