forum

Email notifications are working.

Thanks

OK, that's a relief. I just did a fresh re-installation of everything and got the same problem. Glad to know the problem isn't on my end.

Please keep us posted.

Thanks

The system has been working perfectly for a few days then suddenly I'm getting 'NotificationChannelEmail error' every time it tries to send an email.

I haven't changed anything at all. The email account is working and able to receive emails.

Is the Z-Wave email service working?

maybe it helps, i'm now happy with a clean install (Raspy3) and wlan working: I can't thank you enough for this! This is brilliant and it is working perfectly. I spent a LOT of time trying to get Wifi to work and it was MUCH more complicated and didn't work as well as this. I have no idea how you c...

I did an experiment. I re-installed the Z-Wave/Raspbian Buster image. I connected the RPI with an ethernet cable. I updated Z-wave to 3.2.2 and connected my Fibaro motion detector. I set up email notifications for the "on" event and I am now receiving emails! Apparently, the method I used ...

Great idea. I'll do that and report back.

Thanks for the suggestion. I have installed tcpdump and I'm monitoring the ip address of the rpi.

There are lots of packets being sent but I'll have to figure out what they mean.

Yes, the Pi has internet access via Wifi.

I can confirm it has a working connection because 'sudo apt-get update -y & sudo apt-get upgrade -y' works perfectly

Thanks for your reply. If anyone could confirm that email notifications are working on their device, that might rule out a problem with the z-wave.me mailing system. Also, I just set up the mobile app on my android phone and set Z-way to notfiy me via the app of motion detection and it doesn't work ...

I spent the last several days setting up Z-Way on a Raspberry Pi 3 B with a Z-Wave card. I started with a fresh installation of the full image found on the z-wave.me website on a new SD card. My RPI is connected via wifi (This was quite a challenge!). I have updated Z-Way to 3.2.1 It has been quite ...