official forum

ssl нужно верное время.
Убедитесь, что там при старте запускается ntp и его верно выставляет. И только ПОСЛЕ этого запускается коннектор.

Is any objective answer exists?
Does the razberry catches 'switching commands'?

Yes, that is ok. Razberry IS in the association group. Sometimes as the only device there. So, switch has to send switching command to the associated device, i.e. to razberry, yes? Ok, But on the razberry side nothing happens. Literally nothing - nothing received, nothing is written to the log (in v...

On inclusion of a switcher Razberry associate itself with every group. So I expect that touching a switch will sent an event (command) to the razberry. However defining the highest level of log verbosity tells that just nothing happened on switch touching. If I associate a lamp with the switch, I ca...

<t>The manual to the lock is quite short and just refers to 'Z-Wave interface controller's instruction' in order to set/reset user codes and schedule. I've guessed this in 'expert mode' - under 'command class user code' - and it seems to work. However the general part - namely to 'lock' and 'unlock'...

<t>I have two similar Duwi.z-wave.me wall switches<br/> (bought at the same time, have same ver/sdk)<br/> The problem is that one of them is reported as battery powered, but another not.<br/> So, for one switch z-way postpone all the commands, and sent them on awaking, but for another it tries to se...

<r>> GET <URL url="http://pi:8083/ZWaveAPI/RUN/devices%5B4%5D.instances%5B0%5D.commandClasses%5B32%5D.Set%28255%29"><LINK_TEXT text="http://pi:8083/ZWaveAPI/RUN/devices[4]. ... ].Set(255)">http://pi:8083/ZWaveAPI/RUN/devices[4].instances[0].commandClasses[32].Set(255)</LINK_TEXT></URL><br/> <br/> Di...

Did you tried the 'IT happens' way - i.e. exclude and then, reinclude (with re-interview)?

Just curious if any plan to support them?
I know that these buttons were there before 1.4.1, but actually they never works (just fired 'internal server error' being pressed). Now I see that they are completely removed.

So, is any way to invoke the command from RaZberry iface?

I just noted that such command being sent from other devices is not always reach all of them. Especially from remote controller to the switch in opposite corner of the big area.
However this is not a big problem (not reach now? Well, I click 'switch off' one more time).