official forum

I have successfully upgraded my zway network from 2.3.8 to 3.0.0-rc17. Then I excluded and re-included two Danalock V3 devices in S2 mode. That works well via ExpertUI ->network->control etc, but S2 inclusion of the two Danalocks did not work via Devices->+Add new. I tried this several times, by fir...

I just did an upgrade from 2.3.8 to R 3.0.0-rc17. Some of my devices support S2 (e.g. Danalock V2). However, after the upgrade to R3-rc17 none of the device show the S2 icon in Expert mode; they are all either unsecure or S0. Do I need to exclude and re-include the S2 supporting devices to migrate t...

Also in my case some (but not all) of the devices returned to the normal state, but after switching off (and back to on) the power of the whole house, several went to the failed state again; and they did not revert to the normal state, although all devices are fully operational. Changing icons, doin...

I have exactly the same problems; several icons show the warning, but everything works as expected, doing a NIF, or Force Interview does not help, although these jobs complete successfully.

I have a Danalock V3 in my network; at a certain moment it did not respond to lock/unlock command, due to empty batteries. After I requested the battery status of this device in Expert mode via Device->battery->update, Razberry keeps requesting this info forever, although the jobs fail of course. Af...

I was able to fix the login problem by disabling IPV6 on the RPi.
After setting lowering the IPV6 preference in /etc/gai.conf to 100, and a reboot, 2.2.1 works fine again.
(I have not yet tried to upgrade to 2.2.2.)

Same here; but also can no longer login on 2.2.1 from a Windows 10-64k computer. I have two of these computers and they both show the same behavior (for IE, Firefox and Chrome): it is no longer possible to login (spinning wheel for 5 minutes). It looks like it is stuck while retrieving the ID of the...