official forum

Interesting automatic detection doesn't work with my sensor. At this position where you are now make a network test. Hold B button 2-4 sec when purple comes up push again. If you wait to long and you push at yellow you will reset your device to default factory settings. If you device glow green all...

Set device description via expert Ui. You get a big list with all device settings load this settings in your fibaro Ms. Hi Wikibear, The device description included it when adding the device to the network, it is not a problem. https://s32.postimg.org/m4vy0p8kl/device_description.jpg subir fotos gr...

Hi all, I have a Fibaro Motion Sensor 3.2 version (I have other 2.7 version and work fine), the interview is 100% complete, but Motion sensor event not sent or captured for controller. The device only send Luminiscence. Attach log when motion event is sent to controller: [2016-07-04 13:42:00.035] [D...

Wikibear wrote:But if you are not logged in you get an error with login. Not 500 this is an internal server error.

You try:

I try to access via curl like your faq told me on your website: http://192.168.0.5:8083/ZWaveAPI/Run/devices/ZWayVDev_zway_3-0-49-3 I get: "ReferenceError: ZWayVDev_zway_3 is not defined" The header response is 500 Internal Server Error. How can i solve this? It's possible you needs first login: LO...

I need a second attemp to get this sensor to work. Stops at 92% and then i try again and it works. Maybe sometimes its important that you exclude it before include. Its needs long time to get all if interview is complete. After this you can access all sensors. If you want to get data more than one ...

The device Fibaro FGMS-001 with version 3.2 not working. In expert app is showing the interview complete, but not woriking, events aren't send to controller.

I have checked that the interview is completed in expert mode, the inclusion is complete. The problem is Smarthome aplication automatically inclusion report a problem when the problem not exist.

Regards.

Hi all, I have two Fibaro Motion Sensor, one 2.7 version and other 3.2 version. In clean install, I add 2.7 version automatically without problems with smarthome aplication. Later I go to add 3.2 version and interview is not complete automatically, stop in 90%. I reset and retried to include the dev...

I had similar problem yesterday and I solved shutdown -h, then power cycle your box (not just reboot, but unplug power for few seconds!).