official forum

A) 5.37 is out but not really out... According to https://service.z-wave.me/expertui/uzb-stats/versions-graph.html its not even in the list of options... Plotous should chime in here... B) The blinking appears to be a bug... Do a start inclusion / stop inclusion. I have the same behavior on 2 of my ...

Simple question: Does one get any of the benefits of 700 vs 500 when using a 700 device on a 500 controller? My understanding is between the time 500 and 700 was developed, the EU (where I am) relaxed the max tx power devices can put out a bit and silabs took advantage of this... Will I see slightly...

Until a command is sent to the node and no response is received z-way-server has no way of knowing the devices is dead or not. This is how z-wave works. What you are essentially seeing is if the last command was acknowledged or not. If you wish, you can setup a timed command using one of the apps (d...

Is it possible without sending raw data to the zwave adapter to perform a .Set(... command on a node and not have z-way-server perform a subsequent .Get() to confirm the command was accepted + executed?

Thanks.

This is very much related to the following: https://forum.z-wave.me/viewtopic.php?f=3419&t=33704 Using 3.0.6 + 5.36, I have the following behavinor when I start or restart z-way-server: A) The blue light on my UZB blinks. B) Every 5 minutes, NWI explorer frames are sent out. I then go to the exp...

...and magically it stopped for no reason.

I have been playing with priority routes lately so maybe its related? Probably not though...

I rolled back to 5.27 and then to 5.36, same behavior so I dont think its firmware related.

I have recently began optimizing my zwave network here at home since I ditched all the 433.92 inwall's and swithed over to zwave (already had a zwave network for about 4 years now...). I setup zniffer since I have an extra UZB stick. I noticed my controller is sending out "cmd set nwi mode"...

What is SDK 4.24?

Many of my devices are listing this as the SDK... Eg: Fibaro FGS-223...

Any ideas?

Hi! I can confirm. My 2nd UZB arrived this morning, so I did the upgrade to 5.36 (6.81.01)... No problems. Setting priority return routes works fine now :) The callback is correct now, 0x11. [2020-06-18 10:07:19.354] [D] [zway] AssignPriorityReturnRoute Response with callback 0x11 received: received...