forum

Maybe the Heating Control UI is a good start. More complexity can be added later.

Is there a chance the CC will be supported in the future? My Fibaro FGT-001 Thermostat supports it, so there are at leat 2 devices

KR,
rishamee

Hi, I discovered the interview result of the command class ZWavePlusInfo looks a little bit strange for a sleeping battery device. It looks like the Z-Uno sends the wrong information. It sends roleType 5, where I think 6 is expected for such a (RSS) device. The following information is in the z-way-...

Hi, I changed the sleeping mode to ZUNO_SLEEPING_MODE_SLEEPING (and removed the zunoSetBeamCountWU and excluded and included the Z-Uno). I looked at the interview result of the command class ZWavePlusInfo. It looks like the Z-Uno sends the wrong information. It sends roleType 5, where I think 6 is e...

When I request a configuration parameter a job is added in the queue. The server expects the Z-Uno will react immideately, but it does not, resulting in error messages (see below). When I request the parameter and wake the Z-Uno up by hand by pressing the service button (within a few seconds after r...

It does not react when I request te battery-status from the expert-UI, for instance. Neither it reacts when I request te actual value of a confuguration parameter or try to set one. Either it does not act like a FLIRS device, or the controller sends the wrong command.

Hi all, I have a problem when I add a Z-Uno FLIRS-device to my Razberry ZWay controller. It did work in the past, but now after inclusion in de ZWay-expert-UI the device is shown as Mains, Routing Multilevel Sensor. I think the problem started after the upgrade to 2.3.8 Some techncal details: Z-Uno ...

Still no update?

I checked it. No Wake Up Notification for the Z-Uno in the Zniffer History in the last 24 hours. Checked /var/log/z-way-server.log, no Wakeup notification logmessages there (for the Z-Uno). To be sure I checked the wakeup interval, it is set to 3600.

Hi, I have an issue with wakeup too. My Z-Uno wakes up, every 4 minutes. But the wakeup interval is set to 3600 (?). When the device wakes up, it executes setup() and loop(), but it does not send a Wake Up Notification. When I wake it up by pressing the service button 3 times, it sends a NIF to the ...