Z-Way Version 3.0 - Interview buggy

Official announcements from Z-Wave.Me team. Check this forum to get information about new releases and bug fixes.
Post Reply
andy4zway
Posts: 7
Joined: 27 Aug 2019 22:09

Z-Way Version 3.0 - Interview buggy

Post by andy4zway »

I have Z-Way 3.0 installed. After "Start Inclusion" D-Link DCH-Z110 the interview stops at 94%. AssociationGroupInformation" is missing.

I received the following error message (under Experts Page / Association):
Can not configure associations: groups were not reported by the device. Do interview.

Under "Association" in group 1 and 2, I have each entered (#1) Z-Way. And for control "Update from Device" executed.

The interview popular still stands at 94%. In some cases, I could get through expert commands / AssociationGroupInformation / Group 2 / GetName
we're gonna make it to 100%.

But as soon as a new interview is started it stops at 94% again.

With version 2.3.8 D-Link DCH-Z110 was correctly integrated and the interview was finished with 100%.

User avatar
PoltoS
Posts: 5524
Joined: 26 Jan 2011 19:36

Re: Z-Way Version 3.0 - Interview buggy

Post by PoltoS »

In v3.0.0 Z-Way became stricter in Z-Wave protocol (a certification requirement) and devices with bugs in AssociationGroupInformation appears now as not interviewed.

You can bypass it /JS/Run/zway.devices[XXXX].AssociationGroupInformation.data.intervewDone=true

andy4zway
Posts: 7
Joined: 27 Aug 2019 22:09

Re: Z-Way Version 3.0 - Interview buggy

Post by andy4zway »

That was very helpful. I tried it and the interview is now at 100%. Thank you.

192.x.x.x:8083/JS/Run/zway.devices[6].AssociationGroupInformation.data.interviewDone=true

Output -> true

Interview switches to ->100%

CorC
Posts: 5
Joined: 10 Aug 2017 10:34

Re: Z-Way Version 3.0 - Interview buggy

Post by CorC »

Had a similar issue running away 3.0.4 and including a Qubino Flush2 Relay 6.51.09 SDK and AppVersion 5.1 with connected temp.sensor.

It would interview everything except for AssociationGroupInformation in instance 2 [instance 0, 1 and 3 were successful], being stuck at 97%

I had to use this command:

http://xxx.xxx.xxx.xxx:8083/JS/Run/zway ... wDone=true

Post Reply