FGMS-001 motion issue

[10der]

Hi!

I have FIBARO Motion Sensor AKA FGMS-001.
after interviewing zway created some useless devices like fibaro group general purpose / AccelerationX-axis / AccelerationY-axis / AccelerationZ-axis / Fibar Group Alarm / etc...
I'm confused. first strange - fibaro group general purpose - always in on
second - I cannot get realtime motion detection and no widgets for it.
after long investigation I am understand what realtime motion detection I can read like http://127.0.0.1:8083/ZWaveAPI/Run.devi ... a[7].event or
http://127.0.0.1:8083/ZWaveAPI/Run.devi ... a[7].event (8 - motion / 0 - "silence")
so, my question is: how I can access to Motion realtime sensor and why zway do not create Motion realtime sensor widget by default?

PS: now I created HTTP module with polling every one second. My reception hall lamp very happy... but not me.

[Wikibear]

Normally the Sensor must send by itself, if a motion by it self (Earthquake...) or some one move before the sensor. This in real time. The Group button switch on and after X min off.

Some Infos https://forum.z-wave.me/viewtopic.php?f=3422&t=23473

But at this point, i change from Raspi to Raspi 3 and now my sensor don't send real time data. That's confusing me totally like you. But i will open a new thread.

[10der]

Opps.... I have Razberry on Raspi 3... please check in browser
http://pi-zway:8083/ZWaveAPI/Run.device ... a[7].event
is it changed on you moving from 8 - 0 - 8?

[Wikibear]

Start now an issue at git hub. For me fibaro is not useable:

https://github.com/Z-Wave-Me/home-automation/issues/360

[moderator: this Github issue is not about motion sensor but about MultiSensor V2.7!!]

[Wikibear]

Share your experience here:

https://forum.z-wave.me/viewtopic.php?f ... 884#p62884

Read my last post.

[locked by moderator pz1]