OK - I have made a little bit of progress
I installed z-way on a windows 10 Virtual machine running on my Mac using VMWare Fusion 8.1.1.
The Win10 VM could see the UZB1 stick OK and so I installed Z-Way and managed to update the UZB1 stick with my license key and to the latest firmware. I then successful managed to exclude a device (Fibaro Motion Sensor FGMS-001) that was included on another network. This worked OK, so good news so far.
However I can't include any devices. When I click the
Start Inclusion button, I get the message '
Error handling data /ZWave.zwat/Run/controller.AddNodeToNetwork(1)'.
I plugged the UZB1 stick back into the Raspberry Pi (which is running Z-Way 2.2.2) and it can now see the UZB1 stick and I get the same error. When I retry an exclude, that appears to work OK - the UZB1 stick blue light flashes and it returns a message
Device excluded from foreign network (13:45). So obviously communication with the UZB1 is now working but the not for Include.
I did do the firmware update after I had entered my license key - hopefully this won't have caused problem. How do you tell that the license key has been installed on the UZB1 stick? when I entered it, it verified OK. I would have expected when I went back into the license upgrade page that it would tell me the license was already installed - it doesn't do this.
I am obviously missing something, again any help/suggestions would be much appreciated.
