Tampering events?

Vincentoo · Post by **Vincentoo** » 29 Aug 2013 10:08

Hello,

I am looking into the Z-Wave devices tampering events (command class Alarm 0x71) and to see what I need to do in order to get notified when such an event occurs on my device (binary sensor Everspring SM 103).
But it seems this is not (yet?) supported?
I see this in the logs:
[2013-08-29 08:30:43.561] Got frame from device 2 to controller, but command class 0x71 is not implemented

What am I missing here?

Regards,

V.

Post by **PoltoS** » 29 Aug 2013 10:08

New Z-Way code do not support Alarm CC yet. AlarmSensor is supported. This Command Class will be supported in next versions.