ZME_WCD1 problems.
Posted: 25 Feb 2014 12:18
Hey,
I have a couple of ZME_WCD1's that I'm trying to use with OpenHAB via SCENE_ACTIVATION, problem is that I don't see the device having support for SCENE_ACTIVATION even though it says on pepper1 it supports this command class..
I get these command classes;
0x80, 0x70, 0x75, 0x86, 0x72, 0x85, 0x8E, 0x2D, 0x77, and 0x84..
SCENE_ACTIVATION is 0x2B..
I have the following setup in parameters;
1 and 2 if have tried 0 and 1.
11-14 I've set to 4, which should be "Send Scene Activation"..
Any hints ?
I have a couple of ZME_WCD1's that I'm trying to use with OpenHAB via SCENE_ACTIVATION, problem is that I don't see the device having support for SCENE_ACTIVATION even though it says on pepper1 it supports this command class..
I get these command classes;
0x80, 0x70, 0x75, 0x86, 0x72, 0x85, 0x8E, 0x2D, 0x77, and 0x84..
SCENE_ACTIVATION is 0x2B..
I have the following setup in parameters;
1 and 2 if have tried 0 and 1.
11-14 I've set to 4, which should be "Send Scene Activation"..
Any hints ?