I'm curious about something. If I update the routing information for my network several times I can get significantly different results. The first time I may show good connectivity among all the nodes. Run it again two minutes later and I might end up with hardly any connectivity at all (i.e., lots of red boxes in the expert UI).
What causes the variability on such short time scales?
Routing Table and Connectivity
Re: Routing Table and Connectivity
I think this can happen if the connection is not really good or interferers are in the vicinity.
Uwe
Uwe
Z-Way v2.0.1-rc18 on Raspberry Pi
Re: Routing Table and Connectivity
Same for me in the building of my school. Many sensors powered by usb and showing alternatives routes. Sometimes it's green, sometimes yellow and sometimes red. But I don't know why