forum

Hi,

I have a Qubino flush 2 relays controlled by a Razberry with the latest Z-Way software. Everything works fine, but I want the controller to have more control on what happens on the module.

For example, if the switch I1 is toggled, I don't want the relay Q1 of the same module to be toggled; I want the relay Q2 of another module to be toggled. And Q1, I want to control it from some other module's switch. My move to Z-Wave is for being able to completely re-configure what switch controls what light without having to re-cable the house.

• * Is it a limitation of this particular module?
  * Is it a limitation of Z-Wave?
  * Or is it a limitation of Z-Way?

I was expecting to be able to decouple the switch from the actual relay and control everything separately by software.

Thanks for your help.

I strongly suspect it is a module limitation -- most consumer modules can't be configured to 'require' a controller to function.

Z-Wave.Me modules do support this