forum

hi

I can get the status of my switch by this

http://ip_raspberry:8083/ZWaveAPI/Run/devices[3].instances[2].SwitchBinary.data.level.value
I get true or false back in my brower

but I can't find the code to get my temperatur from my SensorBinary
it is a Univeral Binary Sensor FGBS-001 with a DS18B20 sensor

devices[4] and instances[3]
can someone help

Claus

try: where x=3 through 6 for the respective four temperature sensors.
Note the sensors should be connected to the device while you include it. So you may have to re-include.

pz1 wrote:try:

Code: Select all

http://ip_raspberry:8083/ZWaveAPI/Run/devices[4].instances[3].SensorMultilevel.data[1].val.value

where x=3 through 6 for the respective four temperature sensors.
Note the sensors should be connected to the device while you include it. So you may have to re-include.

Yes this is working! Thank you
with device 4 and instances 3

Claus