How to include z-wave device within new Z-Wave Smart Home?

[leonski]

Hi there,
Must say that I am quite new to the Z-Wave technology and especially Z-Wave on a Raspberry Pi.
Could someone please explain how to include z-wave device within new Z-Wave Smart Home web server?
I am trying to add (include) Fibaro Motion Sensor but without any luck. By clicking on “Start Inclusion” button and quickly pressing Fibaro sensor button three times I don’t see any changes on the page? What I am doing wrong?
Thanks in advance.

[pz1]

Do you get at this screen? If yes, how far is your device apart from the ZWave controller? Best is to have them both on a table

Include.PNG (11.62 KiB) Viewed 10902 times

[christian.paetz]

In > 90 % of all cases the device is already included Please exclude the device first. Also make sure that the motion sensor is in proximity to the razberry. The image above is correct. When you see this you need to tripple click the little button.

Reg. Chr

[Mike Yeager]

I can't get into the smart home interface. It's asking for a username and password and nothing I give it (including admin/admin) is getting me in...

[PoltoS]

Windows or RaZ?

[platenspeler]

I have same issue: After upgrading the new interface comes up, but neither admin/admin nor anything else seems to get me in. I do use windows btw. Is there a way to reset the password on the Raspberry?

Thanks,

Maarten

[kali]

Try logon on local adrress (like 192.168...), no on public IP, as admin.
In apps seetengs you shoul use checkbox: access your controller from outside the home.

[vvuu]

maybe some range problems with including?

and try opera to log in, for example by the IE i cant't log in, with firefox i can't get login dialog, only opera works for me ok..