forum

Hi, I'm new in home autmoation.

My configuration is Raspberry 1 B+ and the z-way board. Raspberry operationg on OSMC + Z-Wave software installed and working.

I have a "Error handling data from server" message. I found some suggestion on internet but nothing work.
The board is working (1 second blink), ttyAMA0 is present.

Do I have to configure some GPIO ports to make it work? Maybe some gpio wiringpi configuration? I have already installed it.

Regards,
Rafal

No need to make gpio settings. I don't know OSMC, so have to leave that to others

OMSC is not officially supported. I believe you need to check port configuration - that it is not used by kernel debugging or console and it is called ttyAMA0 and not ttyS0 as it is on some platforms.