Stuck in an "SwitchMultilevel Get" loop
Posted: 04 Sep 2015 00:30
Hi,
I recently had a fatal corruption on my SD-card and had to reinstall my RPi. When I tried to bring the z-wave system up not all of the devices wanted to play ball, but excluding them and including them again seemed to do the trick.
However, I am now stuck in a loop where there are tons of SwitchMultilevel Get-commands being sent, so my queue is always full (see screenshot 1).
I am fairly new to this, so I need a bit of help to debug this.
I have tried upgrading to the latest version (2.1.1), without any luck.
I have also tried to reboot the Pi, without any change in behavior.
The requests goes out to two dimmer (Fibaro Dimmer2), which was the ones I had to reinclude.
I also notice that the interview with them never completes for instance 1 and 2. (See screenshot 2).
I recently had a fatal corruption on my SD-card and had to reinstall my RPi. When I tried to bring the z-wave system up not all of the devices wanted to play ball, but excluding them and including them again seemed to do the trick.
However, I am now stuck in a loop where there are tons of SwitchMultilevel Get-commands being sent, so my queue is always full (see screenshot 1).
- z-wave queue.PNG (95.03 KiB) Viewed 3419 times
I have tried upgrading to the latest version (2.1.1), without any luck.
I have also tried to reboot the Pi, without any change in behavior.
The requests goes out to two dimmer (Fibaro Dimmer2), which was the ones I had to reinclude.
I also notice that the interview with them never completes for instance 1 and 2. (See screenshot 2).
- z-wave interview 2.PNG (43.3 KiB) Viewed 3419 times
- z-wave interview.PNG (65.09 KiB) Viewed 3419 times
