forum

Hello,
I recently registered since I'm a newby in smart home.
I'm using the z-way stick for wd Nas and already included the Fibaro Wall Plug and the multi sensor.
Using a scene I could recently set up a configuration to activate the switch motion-controlled, but I failed to create a schedule based setting. (scheduled scene fails as well as logical rule).
Maybe anyone can assist me in the first steps?
Thanks

If you're trying to check for one condition and then another, try making sure the first entry into the logical rule is NESTED. I was trying to create one condition and then nest the next under it but discovered that the first entry had to be NESTED and then created the way I thought.

Hi,
I could solve the problem: the time was set correctly, but the time zone on the NAS was wrong... Therefore my scheduled program did not work.