forum

In fact, I seem to have a very similar bug as Dridl had here: https://forum.z-wave.me/viewtopic.php?t=21983&p=57998. I'm also using a ZME_UZB1 and get that very same log message when trying to start "inclusion mode". Unfortunately no solution was posted, so I'm rather clueless what to do here?

How to detect if this is a licensing issue? And what to do in this case?

I can provide full logs, if needed.

Please provide full log from start to load of devices. Do you have clean UZB1 or you have a license loaded (more correct: are you expected to have it)?

Well, I expect it to "just work". I wasn't aware that a license is required, or even that it can be obtained separately, before searching the Internet for similar error reports and finding this forum.

Log's attached.

PoltoS, did already you had time to look at the log file?

Your UZB have no license loaded. You need to buy a license (or get it from your shop if you payed for it).

Here you can get more info on pricing:
http://store.zwaveeurope.com/advanced_s ... zb&x=0&y=0