I'm not able to get my logical rules to work. I try to switch my lamps on when my multisensor sees movement between 6 and 8 am with a logica rule. I see activity on my multisensor, but the lights stay out. What do I do wrong?
This is what I did:
Logical rule in the 'Smarthome UI'
I've set the rule as 'active'
Nested conditions
Boolean operator: and
Time condition >= 06:00
Time condition <= 08:00
Multisensor = on
Actions:
Dimmer, level 40
Logical rule doesnt work
-
- Posts: 34
- Joined: 21 Sep 2015 15:47
Re: Logical rule doesnt work
Hi
I had a similiar Problem, which was caused by wrong time zone setting.
Regards
I had a similiar Problem, which was caused by wrong time zone setting.
Regards
Re: Logical rule doesnt work
Hi Coffeelover,
Thanks for your answer! Where do you set the time zone? I have the correct time in the menu bar of the UI.
Regards, Henk
Thanks for your answer! Where do you set the time zone? I have the correct time in the menu bar of the UI.
Regards, Henk
-
- Posts: 34
- Joined: 21 Sep 2015 15:47
Re: Logical rule doesnt work
Hi Henkhaak,
I am using the WD NAS with Z-Wave USB Stick. Therefore I have to update the time zone on my NAS. Make sure it is not just to have the right time, but also the right time zone.
Regards
I am using the WD NAS with Z-Wave USB Stick. Therefore I have to update the time zone on my NAS. Make sure it is not just to have the right time, but also the right time zone.
Regards
Re: Logical rule doesnt work
If you have raspbian, use "sudo dpkg-reconfigure tzdata"