forum

Just upgraded from an early v2 package...

The new UI is a nice improvement. However, two of my devices are show their default names ("Switch 8:0"). When I go into the device settings page, change the name, and hit save, the name is not updated.

What am I doing wrong?

- Mark

Can you rename others? or same issue with all?

Hi there,

I have the same problem: I can update the device name, but when it comes down to Logical rules (or other apps) not my configured name is shown but the default one. This occurs to me since I switched from the version that was shipped with standard image (downloaded from http://razberry.z-wave.me/index.php?id=24) to the v2.2.0 one via 'wget -q -O - razberry.z-wave.me/install | sudo bash'.

Any suggestions?

EDIT: I've seen that there is a new version out there. Give it a try?

Yes, please give it a try and report to github if the problem is still here.