re-inclusion
Posted: 02 Dec 2015 00:32
I have been setting up my first z-wave system based on the razberry and have run into a problem:
In some earlier tests I had communications issues with some of the devices I added (not a good enough mesh) and these I ended up removing two devices as "failed".
Now I have grown my mesh out a bit these are be in a better position to be part of the system, unfortunately I can find no way or re-adding them.
I do notice when i switch them physically I receive data:
These are Fibaro FGS222. I have attempted the "node" reset by holding down the "b" button, but no luck. Anyopne have any ideas?
In some earlier tests I had communications issues with some of the devices I added (not a good enough mesh) and these I ended up removing two devices as "failed".
Now I have grown my mesh out a bit these are be in a better position to be part of the system, unfortunately I can find no way or re-adding them.
I do notice when i switch them physically I receive data:
Code: Select all
[2015-12-01 20:12:44.220] [E] [zway] Got frame from device 4 to controller, but device is not registered - do re-inclusion
[2015-12-01 20:12:44.802] [D] [zway] RECEIVED: ( 01 09 00 04 00 04 03 25 03 00 D3 )