forum

Hello to everybody
Excuse for my english ...
I have a question about rele step-by-step.
At the moment in my house i have 2 ligths with 4 classic wall switch and one relay (finder).
When i push the first time all light switch on
When i push the second time 1 light switch off and one switch on
When i push the third time 1 light switch off and one switch on (in opposite mode)
When i push the fourth time all light switch off (in opposite mode)

Can i change this traditional rele with z-wave rele? (For example Fibaro FSG 211). I want manage the 4 state.
It's possibile ?
Thank you
Rumcooler

I haven't done this myself, however I believe what you need to do is using the "Scene" app, create a different scene for each light state.

Scene 1
On / On
Scene 2
On / Off
Scene 3
Off / On
Scene 4
Off / Off

Once you create the scenes, then use the "Round Robin Scene Switcher" app to glue the sequence.

Hi Viper384 thank you for your reply.
I have little knowledge about "Scene" app.
Could you give me some information (or example). Is there some information (book or guide or example...) about
"Scene" app or "if then" app.
Scene app has three if condition and the only action is start another scene... How can switch on a light with "Scene"?


Another question:
Z-Wave Qubino Flush Relay is supported by razberry?
Thank you
rumcooler