forum

Hello,
First time poster and trying to get my head around this system.
After I upgraded to V2.2.1 I'm unable to access the Expert UI from Port 8084, all I get is the following message.

Webif is switched off. You can switch it on from Z-Way UI or box shell

I have not been able to find where I can switch it on, can anyone help please?

Log in as admin on port 8083,
Go to your account settings and there is a checkbox to enable the expert UI

Good luck

Click the tools icon in the top right corner, select Devices from Dropdown menu and you get the link:

^^^

Nup,

All I get from the devices menu is:

What Z-Wave controller do you have? If so do you have the Zwave module enabled on the correct port?

It's a Popp Hub.

Sorry, I don't know that rig. Better send this question to the store where you bought this, or to Popp directly. They are primarily responsible for proper functioning

That's strange, as this only started after I upgraded to the latest firmware version.
As far as I can see there is no difference in the Popp as it's a RP2 with the Z daughter board!

It looks as if your Z-Wave is not properly running. I your Z-Wave app active"? what port?

OH ! I got the same thing but I didn't got it correctly the first time...

1: This is not the Expert UI but the "mongoose" interface. Expert UI is on port 8083 and the Webif is on 8084 (right ?)
2: I got it event after updating firmware
3: I thought that I may have disabled some app so I reinstall my whole Raspberry + Z-Way but no luck !