Razberry and I/O
Posted: 08 May 2016 20:59
Hi all.
Just a quick question.
I have a project that needs at least 6 Digital Inputs (all devices are 0V Contacts / Form-C) and I want to add this equipment to my existing Fibaro Home Controller Network.
I would like to use a Razberry or similar to provide a link onto the Z-Wave network where I could present a series of Digital Inputs to be utilised with the Fibaro Controller.
I see a lot of info about using the Razberry a Controller, but not as a Device?
Any information would be great as i'm just starting out with both Raspberry Pi and the Z-Wave Daughterboard and haven't purchased any equipment yet.
Cheers.
Just a quick question.
I have a project that needs at least 6 Digital Inputs (all devices are 0V Contacts / Form-C) and I want to add this equipment to my existing Fibaro Home Controller Network.
I would like to use a Razberry or similar to provide a link onto the Z-Wave network where I could present a series of Digital Inputs to be utilised with the Fibaro Controller.
I see a lot of info about using the Razberry a Controller, but not as a Device?
Any information would be great as i'm just starting out with both Raspberry Pi and the Z-Wave Daughterboard and haven't purchased any equipment yet.
Cheers.