Page 1 of 1

How to factory default the RC2?

Posted: 29 Aug 2016 21:55
by Nomader
I am having trouble with the RC2 remote control
I reset my network controller before I was able to exclude the remote control..
Now after I fixed my controller I am installing everything from scratch.
But now I can not include the remote to the network, as I am unable to bring it to factory default, because it was never excluded properly.
Is there a way to factory default the remote?

Re: How to factory default the RC2?

Posted: 30 Aug 2016 12:45
by Nomader
Just for anyone in a similar situation..:
I managed to remove it using OpenHab2..
sadly domoticz could not do it