forum

I have the UZB1 on a windows pc. Whenever I reboot the pc or remove the stick and replace it (or even when there is a power outage), the routing is reset. It starts routing from scratch all over again. This actually results in dead nodes. i would have to restart domoticz server to eliminate the dead nodes. Is this normal?
Is it normal for the routing to be erased with the removal of the stick or a reboot?
The Aeotec stick has battery, does that prevent it from forgetting the routing, but i am not sure how long would the battery last.
thanks

UZB has EEPROM that survives power off. If your UZB has problems, may be it is faulty. Please send to support logs of Z-Way before and after restart to analyze.