forum

I have an old Wallc-s and 4 new Wallc-2 modules and I am using them with a Fibaro HC2.
The old wallc-s is no problem, Ik have programmed it wit LUA in the HC2.

The new Wallc-2 however is a complete other story.
I can include them in my network but
- they don't get a device template (which is not a big problem, I can set the parameters manually)
- the property SceneActivation is missing. Now that is a problem because I need that property to detect a trigger and put my LUA code at work.

Is the fact that I do not see this property a Fibaro issue or a Zwave.me issue and what could be the solution.

also look here for more information
https://forum.fibaro.com/index.php?/top ... ment-99390

The new device follows newer Z-Wave Plus rules and their support in Fibaro was broken few months ago. We have reported that to Fibaro, but there are not much we can do beside wait for them to fix it.

Dear madam, sir,

I recently bought 4 zwave.me wall switches Zwave.me WallC-s2 (new version) because it seems to me a good module for my needs. I use already the WallC-S to my satisfaction with a HC2

The new version however is not working. At least due to the fact that the property "sceneActivation" is missing to trigger a scene.

I posted two problems on the Fibaro forum but so far no helpful response.

https://forum.fibaro.com/index.php?/top ... me-wallcs/

https://forum.fibaro.com/index.php?/top ... -template/

Zwave.me states that this is due to the fact that Fibaro is not supporting ZwavePlus for this device. See

https://forum.z-wave.me/viewtopic.php?f ... 565#p64565

As a customer who paid serious money for these modules, I don’t want to get involved in a yes/no battle between the supplier of the module and the supplier of the controller, I like to have a working system.

So please check what is going on and repair as soon as possible this problem so that I can switch on the lights in my house.



Best regards



Robert