forum

Just received the new board (stamped with a U) and installed in a new Raspberry Pi3. Loaded with 2.2.5 and I can change the frequency to US but it doesn't survive a reboot. Once bounced, it's back to RU. Going to 2.2.3 is obviously not an option as I cannot change to anything other than 'RU'.

all device zwave a try add is US frequency but it not working. a try reinstall the raspbian With several versions, but nowhere has it worked, I have a device that works on the RU frequency And adding it works but any device in US frequency not.


at reboot the server-log show its:

[2016-11-25 19:19:57.501] [D] [zway] SETDATA controller.data.frequency = "RU"
[2016-11-25 19:19:57.501] [zway] Job 0xf2 (Change/Get Z-Wave.Me firmware frequency): Done
[2016-11-25 19:19:57.501] [D] [zway] Job 0xf2 (Change/Get Z-Wave.Me firmware frequency): success
[2016-11-25 19:19:57.501] [zway] Removing job: Change/Get Z-Wave.Me firmware frequency

I do not know what to do

Grateful for any help you can give me...

Hello,

you cannot a RU Controller change to US.

You can only change to EU,IN,CN or MY

Best regards

Z-Wave Support

the controller stamped with a U, on the chip... i solved the problem, I change the frequency to US and later in the app mobile ADD the device.

There is a problem in the f/w that it reports incorrectly RU while it is on US. Don't worry, everything should work.

If you update to 5.04 f/w (if you are not on it), it will be solved automatically.